Chimney Sweep · Nashville, TN
Chimney Sweep in Millersville, TN
Millersville chimney sweeps for chimney cleaning and sweeping, chimney repair, fireplace repair and more. Certified sweeps, a camera inspection with the cleaning, repairs quoted in writing, across Sumner County and the rest of Middle Tennessee.
Estimate request
Wood, gas, or a fireplace that will not draw?
Straight to us, and a reply the same day.
Brick, age and weather on Millersville chimneys
Eighties and nineties houses have masonry chimneys with cracked crowns and prefab units past their service life; the camera tells which repair is real.
A fireplace on a rental is inspected before each tenant, because the liability of a chimney fire is the landlord’s.
In a fast-built town the fireplaces are gas units of the same age, and the service is a cleaning and a safety check on the vent and the valve.
Brick-veneer houses have masonry chimneys that crack at the crown and the shoulder, and water is the cause; the repair is the crown, the cap and sometimes the flashing.
The site affects the chimney at the top — trees that drop into the flue, wind off the water that drives rain into the cap — and the inspection starts with the cap and the crown.
Millersville at a glance
Fireboxes, flues and caps we see here
- Housing stock
- Mostly 1980s and 1990s; median build 1993
- County
- Sumner County
- Ground conditions
- Rolling clay along the I-65 corridor, in two counties
- Permits issued by
- City of Millersville
Services
Sweeping and chimney repair in Millersville
Chimney Cleaning and Sweeping
Removing creosote and soot from the flue with the room sealed and put back exactly as we found it.
Learn moreChimney Repair
Crowns, caps, flashing, liners and brickwork — the whole stack, priced from what a camera actually found.
Learn moreFireplace Repair
Gas logs, wood inserts, dampers and fireboxes repaired, plus a fireplace that smokes into the room, traced to its cause.
Learn moreOutdoor Fireplace Install
Built outdoor fireplaces and chimneys that draw properly, footed and flued to code rather than stacked to look right.
Learn moreChimney Inspection
Camera survey of the full flue, graded to the CSIA levels, with the footage shown to you rather than described.
Learn moreCaps, Crowns & Flashing
The three places water actually gets in, repaired or replaced before it reaches the firebox.
Learn moreLiner Installation & Relining
Stainless liners sized to the appliance, which is what makes an old chimney safe for a modern insert.
Learn moreChimney Masonry & Tuckpointing
Repointing, rebuilding above the roofline and replacing spalled brick, matched to what is already there.
Learn moreWhy homeowners here call
What sends Millersville homeowners to the fireplace
The freeze-thaw cycle here is what destroys crowns and mortar joints. Water gets in during a wet December, freezes, and takes the brick face with it.
- A damper that will not open or seal
- Black, shiny deposit visible in the flue
- Smoke pushing back into the room
- A sharp, tarry smell in warm weather
Skipping the inspection. A sweep cleans what it can reach. Only a camera tells you whether the flue behind it is intact, and a cracked flue is the failure that actually starts house fires.
Nearby
Chimneys we sweep in surrounding towns
FAQ
Your Millersville chimney and fireplace questions
Do you cover Millersville, TN?
Yes. Our chimney technicians cover Millersville and all of Sumner County, with Ridgetop, Goodlettsville, White House, Greenbrier inside the same routes.
How much does chimney sweeping cost in Millersville?
A chimney sweep in Millersville is priced per flue once the camera has shown the buildup, with the inspection included; repairs — a crown, a cap, a liner, tuckpointing — are quoted from what the camera finds, with the photographs, before any work is done. A fireplace on a rental is inspected before each tenant, because the liability of a chimney fire is the landlord’s.
Who issues permits for chimney sweeping in Millersville?
City of Millersville permits a chimney rebuild above the roofline in some jurisdictions and a liner installation on a gas conversion; a sweep and a cap need none.
How quickly can you get to Millersville?
A sweep in Millersville is usually within a week or two, longer in October when everyone remembers the fireplace at once; a chimney fire or a smoking fireplace is seen within a day.
What areas around Millersville do you serve?
Chimney technicians serving Millersville also cover Ridgetop, Goodlettsville, White House, Greenbrier; the routes run through 101 towns in 12 counties.
Free estimate
Have your Millersville chimney swept and inspected
Tell Nashville's Chimney Sweep what you burn and what you have seen at the Millersville fireplace; the written estimate costs you nothing.